VARIABLE-REACH BOTTOM LOADING ARMS AND UNLOADING ARMS
For loading and unloading over a large area
By working at ground level, the risk of falls from a height is avoided
Saves space in its stored position: the bottom arm frees up floor space
Strengths and specificities
- All-fluids loading arm for loading and unloading gases
- A rigid, technical and reliable structure can be used over the long term rather than a hose for superior productivity
Conditions of use
The conditions of use depend on several factors (installation environment of the arms, service conditions and fluid characteristics). Let's find the right loading arm for you: send us your SDS (safety data sheets).
STANDARD TECHNICAL CHARACTERISTICS OF THE BOTTOM VARIABLE-reach loading arm and unloading arm
- Steel or stainless steel construction as standard
- Balancing using gas-spring compensators as standard
- Side, right or rear truck connection
- Top, bottom or side feed
SECTORS
All sectors - gas applications included
optional equipment available
- Fastened with a support bracket
- Pneumatic assistance (helps with handling the loading arm) and remote control with reinforced sleeve
- Single butterfly valve or double offset butterfly valve
- Ball valve
- Remotely controlled valve opening/closing control
- Drain valve
- Locking in storage position
- Position detector
- Electric tracing or double jacket heating of the arm (heat-transfer fluids)
- Thermal insulation
- Couplers for the connection to the top of the tanker
- Emergency disconnector
- Specific paint finish
- Specific coatings on request
- Atex archiving
- Also available in a double version for bottom loading (loading and unloading of two liquids or gases at the same time ensured by two distinct loading arms or unloading arms).
Not suitable for food applications (no FDA compatibility) - For your food applications, see the product information sheet on Pacquet's Porteflex® hose holder (hose support system)
Specify ATEX zoning if applicable - CE marking for pneumatic, electrical equipment, or equipment used in ATEX zone - Specify if the loading arm is subject to the EU pressure equipment directive